Recent content by Bushog

Looking for some of the Speer soft point and hollow point jacketed bullets with the 3/4 copper jacket. .44caliber: 4447 240gn soft points 4435 225gn hollow points .41 caliber: 4417 210gn soft points 4405 200gn jacketed hollow points PM with what you have and a price? Thanks

Sorry folks...barrel threads....

How different are the threads on a 31-1 and an I frame hand ejector in .32 long? Or are they? Thanks

Well...I guess that is what I said. It really depends on what you want to end up with. A K22 cylinder can be re-chambered but it is my understanding that they might not be heat treated whereas a M17 or M18 cylinder will be and will be considerably stronger. But, looking at your gun, there's a...

That's why I had a cylinder chambered in .32-20 too!

Thanks again everybody! This idea idea dead in the water for me. This is why I asked.

Be sure you get a "numbered gun" cylinder. ie a M17, M18, M48. You also have to be sure it's an early enough model to have the "thick" extractor. If it has a serial # stamped on it...no go...As I understand it the early ones with the numbers were not heat treated. Also, if ur looking for a...

Thanks folks. Seems I bought a cylinder to convert but it has already been done. Was there ever an I frame .22mag? I don't know of one.

Is it safe to have an I frame cylinder rebored to .22 magnum and fit to a 22/32? I know length is a tiny problem but I can fix that.

Here are 2 K frames I had done in .327 Federal using centerfire K-frame donors, M17 and M617 cylinders and rebored M617 and M53 barrels. The blue gun has an auxiliary .32-20 cylinder. They're nice.

WTB: .32 cal Gold Dot Bullets Trying to find some .312 Speer Gold Dot Bullets. Prefer 115gn but 100gn would do. PM with price. REALLY want to get my hands on some. Thanks

Bumpity-bump!

I need a couple Model 51 or 34 cylinders, preferably with the cranes but I won't be picky about that. They do need to be in excellent/very good condition. PM me if you have one/some.

Looking for Model 18 and 17 cylinders in excellent exterior/teeth. Chambers themselves of no concern. The M17 cylinders must have the thick ejector used on the older models. Thanks for helping out!

Looking for one with a square butt only. Barrel length doesn't matter. Thanks