Recent content by dbarlstock

Just found the plastic Disconnector has had the right side projection carved off???? Not sure why that would be done unless someone was trying to eliminate the mag safety?? Anyway I ordered a new stainless one - hope this eliminates the problem.

Thanks you John! Wish I lived closer but am in TX. I bought the Sear Release Lever from Numrich and maybe it wasn’t as advertised?? I feel much better about the safety movement. It takes about ten pulls to get the safety all the way off - Thank you again for your very helpful response. God Bless...

Safety still not working properly I tried three different Sear Release Levers - one of which was an untouched factory new one - and two different used 39 series Safety/Decocker units - and have experienced the same problem with all of the above: 1. Hammer down in Safe Mode - if I pull the...

Thank you so much!! I have a couple of used levers I got in a trade last year so will try a fitting!!

Anyone know where I can get a Safety/Decocker for a Model 909? I’ve purchased a couple of similar model units that fit okay but do not function properly- Thanks!!

Yep - dog chewed on it. Thank you so much!! Thought it was okay. I’ll get one ordered. Doc

The slide stop on my S&W 410 falls out of the frame when cycling and turning the pistol at a downward angle. I can’t figure out why? I have field stepped and reassembled it and it continues to fall out. Any suggestions??

It apparently is an anomaly of some sort. Thanks for the response.

Extractor pins Numrich Arms aka Gun Parts West has them SKU 300290 $2.45 for 2 J/K/L/N frames

The number is K36535 not K36565.

Do not know how to add a picture but the serial number on the butt is K36565 with no missing numbers and no spaces between the letter or numbers. The frame is stamped Mod. 15-2. Thanks for all the feedback.

The company in PA had no info on the gun as it was bought in a bulk purchase.

I have a Model 15-2 with the number K3653X on the butt. The frame is stamped Mod. 15-2. The serial number on the frame in the crane area has been removed. The number F3-653X has been etched into the underside of the barrel behind the lug, underside of the backstrap and on the face of the...

Thank you all so much. Will follow all instructions provided and let you know what happens. This is a 1902 HE civilian model in 38 Mil.

Is this caused by a defective hammer edge or the edge on the trigger? Thanks