Recent content by hithard

Gotta love Smith and Wesson. My Dad sends away for his promo mags for his MP40. Ends up with mags for the compact, sure enough after looking at his copy of the promo form he checked the wrong box. So He sends them back with a short note and Five bucks to cover the shipping. Two weeks later, new...

brassmanbrass, he's in LasVegas. He will have what you want in stock, and get it to you quickly. I've yet to be let down.

That's all I have ever run through either of mine. Been using Missouri bullets 180gr.TC with green dot. As far as leading goes, I do get a little. Which comes out very easy with a bit of Copper scrub pad wrapped around brush. Just a few passes and it's all good. I think a bit softer bullet would...

Okay, your definition of timing is correct, and in the event that it is off you can encounter alot worse problems than just bad accuracy. If your cylinder fails to lock up and you fire with poor cylinder barrel alignment you will shave the bullet, or worse, the bullet will hit the edge of barrel...

I have a 629 w/ 6.5 inch power port. I'm getting a bit of leading from cast boolits. throats are a tad smaller than bore. So I'm looking at sending it out to have the throats opened up a bit. My question is what else would you all recommend having done to this 629-6 while it's in the shop. Any...

I have a 629 w/ 6.5 inch power port. I'm getting a bit of leading from cast boolits. throats are a tad smaller than bore. So I'm looking at sending it out to have the throats opened up a bit. My question is what else would you all recommend having done to this 629-6 while it's in the shop. Any...