629 work-over input

[hithard]

I have a 629 w/ 6.5 inch power port. I'm getting a bit of leading from cast boolits. throats are a tad smaller than bore. So I'm looking at sending it out to have the throats opened up a bit. My question is what else would you all recommend having done to this 629-6 while it's in the shop. Any pistol smith recommendations also?

Thanks for your input.

Greg

 

[hithard]

I have a 629 w/ 6.5 inch power port. I'm getting a bit of leading from cast boolits. throats are a tad smaller than bore. So I'm looking at sending it out to have the throats opened up a bit. My question is what else would you all recommend having done to this 629-6 while it's in the shop. Any pistol smith recommendations also?

Thanks for your input.

Greg