Recent content by joe vitale

I MAGNITIZED A SMALL SCREW DRIVER NO LUCK!ITS GOING TO HAVE TO GO TO THE SMITH.

I WILL LOOK AT THE TOOL SHOP FOR A POINTED MAGNETIC ROD.EVERYONES ADVICE IS HELPING. THANKS IF I WOULD HAVE ASKED HOW THE PIN AND SPRING WENT IN BEFORE I PUT IT BACK TOGETHER,I WOULD NOT BE IN THIS SITUATION.

I did try the compressed air thanks for the advise I will try tommorow,and let you know.

I BELIEVE I MUST HAVE MESSED UP.WHEN I UNSCREW THE SCREW ON THE TRIGGER GUARD I SEE THE PIN NOT THE SPRING.THE PIN WILL NOT COME OUT.I HAVE TRIED AIR PRESSURE DID NOT WORK TO DISLODGE PIN AND SPRING.I AM PREPARED TO SEND THIS PISTOL TO S&W GUNSMITH DEPT.,BUT IF ANY FORUM MEMBERS HAVE ANY ADVICE...

THANKS JJ2AM44. JUST GOT TO GET THEM OUT.

thank you vm for the parts listing and diagram. I am going to try and explain my new issue.During the process of oiling the gun(model 29-no # 4 screw) up yesterday I took the screw out in front of the trigger(earlier I said I did not touch any of the 4 screws I was wrong I did).The cylinder...

thank you all, The oil running down the ejecter slide worked.I did not have to touch any of the four screws to corect this problem. I was able to find the model number the pistol is a no dash 29.I have another issue I will be asking for help later today on this forum.I am trying to get a...

THANK YOU , KKG AND OTHERS I HAVE CALLED SMITH AND WESSON AND GOT THE INFO ON HOW TO SHIP THE PISTOL.I WILL LET IT SOAK UNTIL 2-20-09. I BELIEVE I HAVE A MODEL 29-1 8 3/8 INCH 4 SCREW SERIAL #S206791 I CAN WORK ON A HARLEY BUT I SEE THIS NEEDS MORE TENDER CARE.

thanks for all the advice,hope it works will updat after 6pm.

I will de-grease the spring loaded area in front of the ejector rod.There is a very tiny pin sticking out of the under shroud you mentioned.

sitting around for thirthy-five years means,the pistol was sitting in a pachmayr gun works super deluxe case for 35 years.I will lube it up and let it sit tonight.There is light rust in the barrel,that i believe will clean up fine. there is nothing stuck in the forcing cone,I can see the gap...

yes i am sure the gun is unloaded!yes the trigger will not move,and the hammer will not move. thanks for the welcome

I am a new member with a old problem.I have been on the forum for a hour and i have already learned alot.Thank you all. The model 29 I have is pre 1965 and has been sitting around for 35 years.The cylinder release latch only moves back.I can't push the cylinder out to clean or inspect the...

I am a new member with a old problem.I have been on the forum for a hour and i have already learned alot.Thank you all. The model 29 I have is pre 1965 and has been sitting around for 35 years.The cylinder release latch only moves back.I can't push the cylinder out to clean or inspect the...