Recent content by Longone

So I was looking at some CCI Blazer ammo on their site and noticed a restriction for the 5200 and 5201 9mm. Both of them have a plated lead bullet, the restriction says not to use in ported or comped barrels. Most likely the plating is thin and if (when) the plating fractures it spews lead in...

What ammo are you using? Have you cleaned the barrel/chamber?

I have the PC model and couldn’t be happier with it. It feeds every hollow point or ball ammo I have fed it. It did come with the new style mag followers so I have no experience with the first generation. The only ammo it’s not crazy about is a truncated cone bullet from Extreme, the first round...

Lightly used OWB holster for a Shield 9mm. $40 shipped USPS L48

I ordered one of these. IWB with Locking Snap Loops, Reinforced Top, and Body Shield - J122 - Jason Winnie Leathergoods Had it made rough side out, very good quality and fast delivery.

356 TSW also comes to mind.

Nicely done, a steady diet of plated or jacketed will make cleaning in the future a breeze!!!

Looking great, perseverance and elbow grease. Remember, it’s layered, carbon and lead so soaking muzzle up is your friend. What’s the beer count?

I’ll bet lack of sales is the reason they discontinued these. Bring it on by, we’ll fix you up.

The bore gets sealed on the breach end (in this case) a piece of duct tape would cover the port, special liquid is poured in the barrel and then a rod is put in the bore. “O” rings center the rod and you connect a wire to the Barrel and to the rod, reverse electro plating the begins. Barrel is...

I have an Outers Foul out unit that really gets the lead out with no scrubbing. Problem is they haven’t made it in about 20 years!!!

Almost looks like lead, does it scratch with a scribe or chip off?

One and only “BTT”

Lightly used OWB model 57 Bianchi for a Shield 9mm 2.0. now $25 shipped L48 USPS flat rate. First “I’ll take it” prefer USPS M.O.

Varget and N320