Recent content by malk415

I was referring to blunt nose bullets for lever actions with tubular magazine

25-20 My plan is to run them through a friends 32-20 resizing die first to make sure the necks are round. I bought two 7/8-14 x 2 bolts and am going to drill one with a 5/16 (.312) bit and the other with a letter L (.290) then finish with the 25-20 sizing die. So hopefully will not loose too...

25-20 Then I am off to a shaky start. I have thirty remington 25-20 brass and after that I purchased some starline 32-20 to reform in several steps. I am using Winchester rifle primers. Loaded up six rounds each using 5 gr. Unique, 9 gr. 2400 and 14 gr H322: powders that I have on hand and...

Gents: Looking for load data using unique in 25-20 wcf with a hornady 60 gr jacketed bullet. Mark

Gents: I have a 9mm shield with the Apex trigger kit and a 5 lb trigger pull. When I dry fire it the front sight jumps slightly left in the rear sight notch when I pull the trigger. This does not happen when I dry fire a 1911 or my Ruger lcp so I do not think it is the way I pull the trigger...