Recent content by pilot1695

@427, the bipod is toward the barrel. It just the angle of the pic. Sent from my iPhone using Tapatalk

Each 3 shots, I look through the scope. I guess more practice is what I need..... Sent from my iPhone using Tapatalk

I did the 3 shot group. Some of them are pretty close, some of them got out far. Sent from my iPhone using Tapatalk

Second time shootings MP-10. Seems I can't get a steady hold when I pull the trigger. Bullets landed all over the place...can you guys give me some advises and tips to improve my shooting. I'm using nikon 3x9x40 scope, Sent from my iPhone using Tapatalk

I have one on my 223 and it is awesome. I did a research, see some people use lantac dragon which is also pretty good. Sent from my iPhone using Tapatalk

Hi there Any of you are using the sure fire muzzle for your mp10? Sent from my iPad using Tapatalk

Hi y'all, any of you use frog lube for your AR? May I have some feedback from it? I went through some you tube videos, seems like it's special because of the natural ingredients. Your thoughts? Sent from my iPhone using Tapatalk

@murdock, I used the break free to clean the chamber, it went smoothly. After cleaning, I still use the hoppe9 for lube. Plan to go back to range to try it out again to see if it's still smooth Sent from my iPhone using Tapatalk

Re torqued, took to range went through 200 rds. Smooth all the way. Thanks all your inputs. But I really am surprised if the jam was caused by barrel nuts torque. Torqued down to 50lb. Sent from my iPhone using Tapatalk

This is what I use for lube And this is the proper one? Sent from my iPhone using Tapatalk

CLP break free, right Sent from my iPhone using Tapatalk

Waywatcher, yeah, the good smell one. So it's not proper for ar? Sent from my iPhone using Tapatalk

Agree, I just can't figure it out. It is always the left side round got jammed from the Pmag. I mean since the 223 round are pushed fed down to the mag. Sent from my iPhone using Tapatalk

Yeah......I admit it..... I m getting a torque wrench to adjust it. Will let you know if the problem is solved.. Sent from my iPhone using Tapatalk

@JaPes, thanks for all the inputs. I have the M4 ramp lined up, but I didnt torque it to the requirement when I install the barrel, just a estimate. I run it only PMC with Pmag and it's been doing that since completion. @waywatcher, Pmag, spike BCG, PMC and hopper 9 lube. Sent from my iPhone...