Recent content by quincybob3343

Where to look for a hand for the above revolver? My gunsmith is a good Smith man and said it should be replaced. thanks, quincyboob3343

Found Model 15-2 with 2 inch barrel. Book states 2 " barrel introduced in 1964. SN is: K805XXX. On lower left of frame is a second number: 81915, what is that #? Also a "Spade," symbol as in the card suite, stamped on right frame and possibly the crane but not very legible. What is the second...

I'll take it; the Lawrence for the Ruger SingleSix. quincybob3343

I am in need of a new(?) plastic liner for my M29 wood box. Does anyone know if they are available, new or rehabilitated? thanks, quincybob3343

Schofield - S&W 624 Ron C, I have a S&W 624 .44 Special, 6.5 barrel. Gun is in very good condition and has very few rounds through it. I am the second owner and checked with S&W in 2005 to see if it was in the recall range which it was not. It came "all alone," no box, papers or tools. I will...

The letter to authenticate a K-22 five inch barrel has arrived! Alas, the news was not good. The gun, K107XXX, was shipped April 24, 1951 to Shapleigh Hardware in St. Louis, Mo. It was one of 20 like revolvers all with six (6) inch barrels. Everything was correct except the barrel length. If the...

K-22 5 inch The gun show was in Las Cruces, NM. We have two big shows here and several smaller ones in-between. Southwest NM is an error, I should have said Southest NM! The verification letter to Roy went out today. If the gun is factory, I will buy it. Maybe even if not factory it may follow...

K-22 5 inch The guy was asking $750 for the gun, no trades, cash only and I was short about $550. Thanks, quincybob3343

At a gun show this weekend I ran across what appeared to be a five (5) inch barrel K-22. The lettering on the barrel was factory and where it should be, not as it would be if a six inch barrel was cut down. About 94%, strong rifling, magna stocks and typically tight S&W action. I did not write...

I have model 651 S&W with box, tools and papers. Also included is a .22 LR cylinder that originally came from the factory with the gun. Gun has been fired some but is in very good condition. Could you guys give a value for the 651? Thanks in advance!

Hand Ejector 3rd model Thanks for the information. The reblue was not done at the factory but is an excellent job. The stocks have the large silver medallions. The right stock is numbered 66 over 227. Stocks do not match gun. So these stocks could be correct for the gun? I will try for pictures.

I have a HE 3rd model .44, 5 inch barrel, serial number 41,3XX. Can someone give an approximate date of manufacture? The HE has magna grips with silver medallions and diamonds around the grip screw. Are they the correct grips? Gun has been reblued (plum colored cylinder?) but makings are sharp...

WTS Lots of Grips! I will take #5 grips for the Beakert revolver. quincybob3343

I was fortunate enough to find a Third Model Single Shot .22 pistol and add it to the collection. The grips are not original, very functional but not original! Any suggestions as to where to look to find the correct grips? Thanks in advance!

I was fortunate enough to find a Third Model Single Shot .22 pistol and add it to the collection. The grips are not original, very functional but not original! Any suggestions as to where to look to find the correct grips? Thanks in advance!