Recent content by rubber ducky

John, Many thanks for the quick reply. That book is on my things of 'to-get's; I'll start by doing that. I've been meaning to get one for a while... Thanks again. rd

Not to completely drift off topic, but are projects such as these (barrel-swaps) do-able with specific hand tools? Are there any good 'tutorials' on-line or otherwise that could point me into the right direction? I'm contemplating a barrel swap project, and would like to get familiar with the...

Roger. I guess that'll mean that I should find start looking for a M-65 or M-66... (I prefer stainless). Unless that is, people have other recommendations. john, many thanks for your help. rd

Thanks for your reply. you got me thinking - and I did what I should have done before posting - measure the outside diameter of the forcing cone area... Sure enough, it was too small for the 686 I have, but matches the 19 exactly. I guess i'm going to have to find me a .357 K frame then...

Hi folks! Long story short, I've had this heavy barrel for a few years, just sitting in my box of parts that i don't use - and was recently thinking about putting it on a revolver. About the barrel - its about 6 inches, and judging by the length of the forcing cone area, i'm assuming its for a...