Recent content by runningute

I have two very nice sets of "The Original Mustang Grips" that were my dads. They appear to be highly figured walnut and I would love to use them. I know they fit a square butt revolver but won't fit any of my K/L S&W's. I don't currently have a "N" frame to try them on. They are marked with...

I have two very nice sets of "The Original Mustang Grips" that were my dads. They appear to be highly figured walnut and I would love to use them. I know they fit a square butt revolver but won't fit any of my K/L S&W's. I don't currently have a "N" frame to try them on. They are marked with...

I have bought and experimented with several powders since I also mainly shoot a Mod. 66 2.5" .357 mag. Power Pistol- the most accurate powder, measures nicely, HUGE fireball and report. Unique-Dirty, smoky, mild-mannered powder. Does not measure as nicely as a ball powder. Win 231/ HP-38-...

Thanks everyone for their replies. I went to the range today and shot these loads. In my 2" .38 special, they were very mild. In my Mod. 66 3"- they were like shooting a .22. I hated to waste good bullets but it was fun with some mild loads. My Power Pistol .357 loads were fun to shoot- very...

Try Alliant's Power Pistol. I have never seen a more "flashy" powder. In my .357 it lights up the range.

Hello, I have loaded the following and am concerned that the load may be too light and pose problems with detonation or the bullet becoming lodged in the barrel: .38 Special Winchester brass case 4.0 grains Unique 125 grain Hornady XTP/HP CCI 500 Primers OAL: 1.470” Gun will be either...

Hello, I have loaded the following and am concerned that the load may be too light and pose problems with detonation or the bullet becoming lodged in the barrel: .38 Special Winchester brass case 4.0 grains Unique 125 grain Hornady XTP/HP CCI 500 Primers OAL: 1.470” Gun will be either...