Recent content by Simone

Hello, i'm looking for a target Trigger and Target Hammer for my S&W K38 (mod. 14) Target Masterpiece. Thanks!

Dear All, thanks a lot for all your answers. About my Lee WC mold i have the suspect that my difficult to dislodge the bullets from the mold can be due just to alloy temperature and maybe also the alloy composition. I don't have a lead termometer but when i decrease the temperature of the lee...

Ciao Paul and thanks. For you "normal lube groovesmold" is the 38 WC Lee mold shown in the picture attached here, right? Because in my opinion my mold with all that grooves is unlucky when i have extract bullets. For this reason i'd like to buy a 3 or 4 grooves mold Lyman or NOE.

Hello, i reload .38 special with wad cutter bullets for my smith&wesson 28 HP and 52-2. Often I cast these bullets with the Lee double cavity mold you can see in the attached picture. I lube the bullets with Lee Alox. Results are good and after 70 rounds the bore is clean without leading. The...

Dear All, thank a lot for all your contributions.Today i replace the Wilson hammer spring with the original smith & wesson spring of the revolver, and i tighten the strainscrew. Now percussion appears more strong and also the lateral friction of the hammer appears to be reduced. Tomorrow i will...

Hello,i need your help for the following problem. I try to sumarize: Last september i buy a S&W 28 Highway patrolman 6" in mint conditions. I shoot with it almost every cartridge available, also reloaded without any sort of issue. The only problem for me was the heavy single action trigger pull...

Here you can see the progress of diassembly. Fortunatly, we try to put the stud in the hole and it is very tight without backlash so we are planning simply to give a strong Loctite glue and stick it in the hole. Tomorrow i give you update. If i can fix this job the next step will be improve the...

Hello, what can i wish more then this? Really a big big thanks for the list of contacts! You have been very friendly! One by one i will contact them. Today i receive after one month the Brownells screwdriver set to disassembly the revolver and fix this problem. I open the box and i find that the...

Yes, i can silver solder the stud with my torch but if i think how are the parts after they are subjected to acetylene flame i would like to choose another less invasive method. What do you think about "mushrooming" the stud head after put it in the hole? Today i receive from Brownells the Smith...

ciao Hondo and a big thank for the support. No, i don't have a new bolt which is the broken part of this unlucky event. It is still mounted in the revolver as you can see in pictures (the pistol when i come back home from the shooting range after the breakdown). I show better with new pictures...

The hole shown in the picture is the broken bolt in the gun where the screwed part is loss together with the thumpiece and the cap nut.:( Thanks. Ciao

Hello, attached here you can see the thumpiece version of the revolver. It is tightened with a cap nut, the exploded view is the original included in the blue box. Which is the right version of bolt? Big thanks to all. Ciao Simone

Hello and thanks a lot for your reply. Maybe I don't use the right term to define the part shown in attached picture. Anyway my father's mod. 60 revolver breaks this part and you can't imagine how difficult is to find spares in my country considering that nobody in USA ships gun spare parts...

Hello, does anyone know the thread pitch of the following screws? 1)Strain screw N frame (i think it is the same for K and L) 2)Bolt screw J Frame Many thanks for your help!!! ciao! Simone

Thanks, i sent you a message.