Recent content by sw702

Cure for broken hammer, the hammer from older models 38 and 49 work great , I like the look also...........

they are a tad bit taller and rear is beefy .....factory sights did not work well for me ,front was too low and rear notch way too wide..............put in vice, tapped out old and put in new,,,,,,,the new front sight has a beveled edge to start and the rear has a lock screw ..........tools do...

Hi, don't like to cook.....like catchup......rough neighborhood

cant cook......................

XS R3D, I like them

IN A G19 GEN 3 THEY WORK PERFECT......... And in a Kel Tec sub2000 Gen 3...... The Gen 3 sub2000 has a 19 grip frame and the Mec-Gar magazines are perfect with there extended base (18rds), they match up to the grip nice............. They do not ruin the magazine release, the mag catch is...

Hey Ciao I like them with Mec-Gars 20 rounder

carbon killer I like Slip2000 carbon cleaner............

very fast contact and payment, PERFECT, thank you

Kahr recoil springs are VERY heavy , I have had three 380s, two 9mms & one 45. well made guns but hard to rack........... sold them.

Two Kimber stainless 1911 9mm 9rd magazines and a Bianchi case. I dont think magazines have been used. 40.00 shipped, check or money order. First Ill take. Thank you

great work Mahovsky's Metalife.........the best IMO........

Transitional Gen 3 frame marked 659 with 659 slide that had a little work........... The Winchester 147gr jhp shot great out of this.

32 ammo Hi, had one years ago with four magazines, three of the mags worked perfect with PMC 32 hollow point, the other mag not so much, pictured is some of my old PMC with a silver tip ............Target sports has PMC 32 hollow point ammo cheap !.....hope this helps

49 looks like a 36-1 barrel........still very cool.........here is my pawn shop buy from years ago with the tapered barrel,,,,, I have never checked to see if it left the factory with the 3 inch barrel