Recent content by tcgrmt

Update with LMT DMR 308 PRS stock

I tried it I purchased this rest combo and returned it. It's a little on the light side for me and didn't hold the my M&P 15 at the height I wanted. The front bag was too short or tall (can't remember which) no matter which way I turned the rear bag.

Anyone installed one of these on a M&P 10? I like the QD sling swivel sockets, wish the Magpul PRS had them like my current CRT does. DMR308 - Buttstocks - Parts

Check the gas block, if I remember right someone on here measured the gas port location and without the hand guard piece and was ok to install flush without a space. I measured my low profile gas block and the hole was large enough to be install flush. If the gas block checks out just keep...

Sorry i thought it was the pin size you were looking for. I installed a 3/4" low profile on mine. This is the the Troy version i installed Amazon.com : Troy Low Profile Rifle Gas Block, Black, 0.75-Inch : Hunting And Shooting Equipment : Sports &...

See the following from another post

I purchased this new a couple of months ago. Installed it and used it a few times. It's a drop in model. UTG PRO AR Style Model 308 Quad Rail System Decided to upgrade to a APEX free floating handguard. Like new, cost $85 new, looking for $50 plus shipping.

I was having the same issue after 150 rounds on Saturday at the range. Last night I decided to give it one more try before sending it back to S&W. I completely cleaned the BCG and upper receiver and then coated them using my finger with oil. This morning when I grabbed the gun out of the safe to...

My tack driver :) At 100 yards today.

These are from today at the range, 100 yds. with a 22 mph cross wind. The top two and the bottom left are M80 ball, the bottom right is Federal 168 gr. Match. 100 yards Close-up of the Federal 168 gr. Match close-up

It's not as big as you think!

The original gas block on my M&P 10 is a stepped hole. The 3/32" punch fits nicely in the hole but the pin is smaller than 3/32". After tying from both sides with the 3/32" punch with no luck and almost getting the punch stuck I tried the 1/16". The pin popped right out. With the pin and gas...

I just tried out my JP Enterprises Recoil Eliminator at the range today. JP Enterprises Recoil Eliminator All I can say is I LOVE IT! After shooting a 100 rounds last weekend and having my shoulder beat to h*ll today was very enjoyable.

Stock M&P 10 charging handle thickness at the roll pin is approx. 0.30", going to order 1/4" roll pins.