Recent content by tyger2

  1. T

    Strain screw stuck

    Update, not a deformed screw head. I checked already with the loop. The is why I am kind of upset with SW PC people. Tried the dental pick idea already and screw driver trick, but not budging. Now letting the screw soak with Kroil and I will give it another shot. What about a heat gun?
  2. T

    Strain screw stuck

    Well, Guess what, the strain screw is not stuck, one the highly regarded gunsmiths at the PC broke his screw driver tip off inside of the slot of the strain screw. Nice. Now any suggestions of getting this out. I about half the length of the slot with the tip exposed. I am not happy.
  3. T

    Strain screw stuck

    I have a Performance Center 627-8 shot. Stain screw will not budge. Does the PC Red Lock tight this screw?
  4. T

    625 reload issue, can not close cylinder

    At the end of the day SW replaced the cylinder and now all is well
  5. T

    NY state bill to require liability insurance as condition of gun ownership

    Same BS here in CT, unconstitutional bills are being pursued. The state is dying. This is not going to help draw people into the state.
  6. T

    Touch up slide, scratches

    I would like to keep the bead blast finish look. The scratches are not deep.
  7. T

    Touch up slide, scratches

    I have marks on the back of my 5906 slide from the levers during reassembly. Is there a way to touch this area up without bead blasting?
  8. T

    Performance Center, pistol services worth it

    I have a 5906 that I was thinking of sending in to the Performance Center for the action package. Is there services worth it?
  9. T

    625 reload issue, can not close cylinder

    The overall length is 1.250. The rounds that are not fitting are Winchester and Federal Brass. Also some of the rounds fit into some cylinder but not others. What is exposed lead?
  10. T

    625 reload issue, can not close cylinder

    Thanks but not the primers
  11. T

    625 reload issue, can not close cylinder

    Reloading issue with 625, 45 acp. Loading 200 grain SWC. Issue is fit in the cylinder. Can not close cylinder. Bullets will fit in a chamber checker (EGW). I even tighten up the the crimp but still and issue. Any tips will be appreciated.
  12. T

    3rd generation action job, Performance Center Service

    Looking at S&W Performance Center gunsmithing service. A 3rd generation action job is $165. Has anyone had this service performed. Is it worth the cash? What should I really expect. I did call S&W customer service and the representative was ignorant on the service.
  13. T

    5906, how to clean dull white dot sights

    Have 5906 with adjustable sights. The white dot rear are kind of grey and dull. Is there a method to clean up the dots without harming the orginal dots.
  14. T

    Model 64 fixed sight issues

    The accuracy is not the issue. The 64 is quite impressive with various loads. I am real happy with the revolver. Let say for arguement that 2" is off at 15 yards.
  15. T

    Model 64 fixed sight issues

    I have a 64 that is is shooting 2 inches to the left. Dead nuts accurate and nice action. I did send the revolver back for adjustmets but still the same issue. Is this something I have to live with?
Back
Top