I got these nice grips. The correct name would be K-frame RB presentation target grips I beleive.
But the fit is not so good. At least not on my 696. This 696 has seen many grips that does fit 100%, the problem lies in the grips.
But when the lower position holes would be relocated I think they would fit nicely. The curve of the grips and frame are the same.
Is this an original S&W with an incorrectly drilled position hole?
Or are there older K-frames that are that much different?
Or, ist this a product of DIY out of a square butt? I do not think so, the way the lacquer is just a bit over the edge on the inside is how I have seen on many original grips.
If these would fit an older type I would leave them as they are otherwise I relocate the holes.
But the fit is not so good. At least not on my 696. This 696 has seen many grips that does fit 100%, the problem lies in the grips.
But when the lower position holes would be relocated I think they would fit nicely. The curve of the grips and frame are the same.
Is this an original S&W with an incorrectly drilled position hole?
Or are there older K-frames that are that much different?
Or, ist this a product of DIY out of a square butt? I do not think so, the way the lacquer is just a bit over the edge on the inside is how I have seen on many original grips.
If these would fit an older type I would leave them as they are otherwise I relocate the holes.
