|
|
08-29-2016, 02:24 PM
|
|
Member
|
|
|
Join Date: Aug 2016
Location: South Texas
Posts: 9
Likes: 5
Liked 2 Times in 1 Post
|
|
460V hammer and trigger problem.
I moved this thread over here after I realized I had posted in the wrong forum. My 460V will not let the hammer or trigger move all the way to the rear. I took it apart and all seems fine inside. The strain screw is tight. But there's a piece of metal that looks like it sits under the cylinder release latch that is causing the hammer and trigger to not move. Here's a pic of the piece. Thanks for any help.
|
08-29-2016, 04:47 PM
|
|
Member
|
|
|
Join Date: May 2012
Location: Evansville, Indiana USA
Posts: 6,245
Likes: 486
Liked 11,461 Times in 3,544 Posts
|
|
That is the part that blocks the bolt from moving forward when (after) the gun is cocked. It rests in the fame slot behind and below the trigger, and cams off of the pin that is in the underside of the trigger. (cam pin in trigger sits in slot in bolt block. When the trigger is pulled back, the bolt block rises into position in front of the bolt.
The link shows the position of the bolt in place in the slot....
ILboltremoved-1.jpg Photo by 500magnumnut | Photobucket
__________________
Ret. LE, FA Instr, S&W Armorer
Last edited by armorer951; 08-29-2016 at 04:52 PM.
|
The Following User Likes This Post:
|
|
08-29-2016, 05:26 PM
|
|
Member
|
|
|
Join Date: Apr 2011
Location: Where this month?
Posts: 3,604
Likes: 264
Liked 4,215 Times in 1,714 Posts
|
|
That'll do it..
Last edited by bigggbbruce; 08-29-2016 at 05:27 PM.
|
08-29-2016, 05:31 PM
|
Vendor
|
|
|
Join Date: Jan 2010
Location: Kansas City area
Posts: 6,239
Likes: 55,795
Liked 13,770 Times in 4,330 Posts
|
|
The end of the hand pin engages the slot in the bolt block on the far side of the trigger. If the pin is under the block, rather than in the slot, the hammer won't go back all the way.
|
08-29-2016, 06:03 PM
|
|
Member
|
|
|
Join Date: Aug 2016
Location: South Texas
Posts: 9
Likes: 5
Liked 2 Times in 1 Post
|
|
Thank you very much for the info and the pics. That was the problem. I put her back together and she works beautifully. Again thank you.
|
|
Posting Rules
|
|
|
|
|
All times are GMT -4. The time now is 09:54 AM.