N frame barrel threads

[AudieMurphy]

I need some Help.If anyone can point me in the right direction. Im refitting an Model 28 Highway patrolman. Changing from a 357 to a 41 mag. I need a N frame barrel die .670X36 die. Brownells doesnt have.I have searched the web hi and low....no dice!...Does anyone know where I can get one. I actually have two barrels that the threads need cleaned up. One looks like someone yanked the barrel without knocking out the pin. Thanks you all.....greatly appreciate it

 

[armorer951]

You might check with some of the tool rental places online, like 4dRentals.


Taps & Dies (rentals) Archives - 4D Reamer Rentals

 

[cgt4570]

I was about to say Brownell's carries them, but it looks like they're out.
Any good machinist or gunsmith should be able to fix it on a lathe. Worst case, with some patience, you can use a thread chaser file.

 

[Yorkie Man]

I installed a 41 Magnum barrel on my Model 28 and the threads were the same.

 

[steelslaver]

They are the same as are all N frames. I have both a tap and a die if you can't find them anywhere else. Shipping and a deposit on them. If a barrel is a bit stick I tun a die on it and tap on frame.

I don't see where 4 D list those dies

 

[AudieMurphy]

They are the same as are all N frames. I have both a tap and a die if you can't find them anywhere else. Shipping and a deposit on them. If a barrel is a bit stick I tun a die on it and tap on frame.

I don't see where 4 D list those dies

I checked the tool rental place....again no dice. I would like to take you up on your offer of letting me use the die for dressing up the barrel.Please tell me how to go about doing this.Im new here.