What tools to cut a single action sear on hammer surface?

P

PzShrekt

Member
Joined
Mar 26, 2024
Messages
12
Reaction score
2
I have this model 15-3 that was a police duty pistol. As you all know, for many police agencies, they would request SW not install a SA sear on the hammer SA sear surface, or they would grind it off.

My 15-3’s hammer sear surface appears to never to have had a SA sear cut into it. I have cut a groove with a precision file and a fire hardened screw driver tip to form my SA sear, but so far no luck on being able to file down the surface to create the SA sear, the case hardening is too strong for my file set.

What kind of files do I need to to file down one side of the sear surface to create the notch for my sear?
 
Register to hide this ad
Welcome to the forum!

I would strongly suggest that you simply buy a new hammer. There are many different sources on the internet.

If you do succeed in cutting through the case hardening on your existing hammer you will end up with a hardened surface (trigger) mating with a non-hardened surface (hammer) and that won't last very long before it wears enough to become unsafe. That's not to mention the geometry and alignment issues that will pop up.
 
I use diamond chip files and they will cut hardened steel.They aren't very expensive. (Ebay) I just "saved" a 629 that had push off by taking a few thousandths off the sear to make the step deeper. It now breaks clean at 2.5lbs and I "saved" the original target chrome flash hammer. It's not rocket science BUT you have to do it with great care!
 

Attachments

  • IMG_9271.jpg
    IMG_9271.jpg
    80.8 KB · Views: 18
Last edited:
So, I can just drop dbl action sear onto the new hammer without fitting and I would get DA/SA functionality back?
 
Diamond files are the only way to file that. It's very difficult to get that job right with a file. The S/A notch is only .007 deep and you have to get it exactly 90 degrees to the sides.

The best way to do it is to use a small diameter (1/8") solid carbide end mill in a milling machine. Then you have precision control over the depth and squareness of the cut. Sadly, most people don't have a mill or access to one.

The Easy Button is to get another hammer, as suggested above.
 
Last edited:
PzShrekt said:
So, I can just drop dbl action sear onto the new hammer without fitting and I would get DA/SA functionality back?
Click to expand...

Get a hammer that has both single and double action sear already on it (almost all of them do). There is a good chance it will be a drop in part without fitting, but not a 100% chance. Sometimes the original D/A sear will be needed, but not too often.
 
Last edited:
What kind of hammer? I’m looking on eBay and there are different inch measurements for k frame hammers, some are .400” and some are .375”, for a model 15-3 .38 special, which hammer should I get?
 
You must log in or register to reply here.

Similar threads

C
629 pre lock single action problem
Replies
12
Views
344
Colt Commander
C
T
Action Job on a 686 w/3" barrel
Replies
3
Views
744
fiveeightysix
F
C
469 Single Action reset?
Replies
1
Views
313
armorer951
armorer951
E
Action stiffens and Locks Up on Model 19-3
Replies
7
Views
712
4K2022
4
B
686 New Model sear and spring
Replies
4
Views
387
dsf
D

Latest posts

Back
Top