Search results

Yes, Ford did re-case color the hammer/trigger- when I purchased the revolver, the case coloring was also stripped/discolored

This makes the most sense!! I wish I could find the before pics (Ford had the revolver about 7 months) and post them..

Yes, Ford did re-case color the hammer/trigger- when I purchased the revolver, the case coloring was also stripped/discolored

I asked Ford to try and bring the finish back to original as possible- I am very happy with the way it turned out, but still puzzled on the stripping of bluing- then sealing the finish..

The previous stripping of bluing appeared to have a sealer applied- and even the case color parts were discolored.

Yes- all serial #'s do match including frame, stocks and cylinder

Thank you, and the stocks do have the same 6 digit numbers as serial numbers on frame and cylinder.

Good afternoon, I purchased a pre model 10 - 2 inch 1946(?) ser# S 839xxx that had the bluing completely removed. The revolver was a metal grey color with a sealer. Since I had never seen or held a pre model 10 - 2 inch- I purchased the revolver. Since the revolver was in great condition and all...

Pre- Model 29 I have a pre-29 shipped in Jan 1957, 5 screw, Ser# 153xxx. With Jinks letter. A Jink's letter should tell you.

Thanks all for the info and examples.

That is what I also believe, but look closely at the 2nd serial # imprint

Has anyone ever seen (2) different serial number stampings on a 1961 S&W 28-2? The correct Serial Number is stamped at the bottom of the grip - where the frame stud hole is. It looks like a stamp before the hole was punched..Please see photo and please comment...

FYI , I have a lettered 44 Mag 5 Screw ser# 153xxx shipped in Jan 1957.. ( I just double checked the letter)

I also have a Pre 29 # 153xxx. My letter says shipped January 1957

A while back, I purchased grips SER# 63147 (Mint) . I would like to re-unite these grips with the gun or purchase the gun from the owner. Please contact me @ craypi@ aol.com

I am really embarrassed, after purchasing new springs , extractor rod etc... the binding still occurred. I did not notice any off balance of any rotation. I then used my new vice grip designed for extractor rods and tightened the LH firmly - Moses parted the sea - it worked!!! Thanks all!!!

Thanks for the info - Hondo- there is no unusual warping or out of round of the cylinder - I will take apart again and look at the internal parts - including the springs - also - Hondo - I bought the SW book you recommended me several months ago - I have the S&W disease - I landed a 1950 or 1951...

Thanks , I don't notice any obvious eccentricity, and I will take this over to the gunsmithing - thanks for the help

I am very new to the group and I have the S&W bug... I have a S&W .38 Chief Special Pre-Model 36, Five Screw Frame variation, 2 inch - round butt/walnut grips, caliber 38 S&W Special that was shipped from factory in July 16, 1953. (all info via S&W Letter) I noticed the plunger - when...