Magpul stock replacement
- Thread starter harrym
- Start date
Register to hide this ad
Vinney47
Member
Any of them.
Magpul offers their stocks in mil-spec and commercial dimensions. Make sure to order mil-spec.
The CTR stock is a good one, has the "friction lock lever" that eliminates all wiggle. It's lightweight, simple, effective, comfortable.
Magpul offers their stocks in mil-spec and commercial dimensions. Make sure to order mil-spec.
The CTR stock is a good one, has the "friction lock lever" that eliminates all wiggle. It's lightweight, simple, effective, comfortable.
UncaGrunny
US Veteran
If the wiggle is your only issue, a small strip of self-adhesive felt or the fuzzy half of a vecro strip applied to the inside of the stock bore does wonders, for pennies in cost.
Majorlk
Member
Absolutely! This is probably the best choice for a replacement stock.
As for the wiggle, a single layer of electrical tape down the length of the lower extension (faux buffer tube) costs less than a penny and will accomplish the same thing, albeit with an inferior, IMHO, buttstock.
Vinney47
Member
Absolutely! This is probably the best choice for a replacement stock.
As for the wiggle, a single layer of electrical tape down the length of the lower extension (faux buffer tube) costs less than a penny and will accomplish the same thing, albeit with an inferior, IMHO, buttstock.
Yeah. I purchased a knock off CTR stock for my 15-22, with a non functioning friction lever lock and a ton of slop. I had heard of the electrical tape method, but there was too much slop for that. Ended up solving that by putting down a layer of the soft side of Velcro tape. I put it down the inside spine of the actual stock, so that it wouldn't show no matter what position the stock is in. I really just wanted that stock for the QD sling attachment on it anyway.
I have a genuine CTR on my M&P15x, and love it.
Last edited:
BD1
Member
Any pics or vids on this
BD1
Member
With the tape or Velcro installed, found some vids on the tube
Last edited:
Majorlk
Member
BD1
Member
This is a touch forum to ask questions, some of us are newbies at this & would like all the info we can get to make the best/ right choice & not have to do it over, just looking at some vids people use different materials, lengths & placements of how they are attacking it? Sorry if I'm annoying some people for asking questions that where probably gone over several times.
Majorlk
Member
It's not annoying, just that virtually question you have asked has been asked multiple times and the answers can be found using the forum's search function and reading the resulting threads.
As for the tape/Velcro installation, just put a four or five inch length on the top of the receiver extension and slide the butt stock back on. It's really a simple procedure.
As for the tape/Velcro installation, just put a four or five inch length on the top of the receiver extension and slide the butt stock back on. It's really a simple procedure.
BD1
Member
Sorry, I'm a little slow, just learned hoe to use the search this forum tool. I was trying to use just the search & was having a hard time finding what I was looking for.
trebor127
Member
CTR for the $75.00 solution, velcro for the $.75 solution!
here in england we have very little of anything to choose from in the way of add ons......could you confirm what colour this magpul stock is
keith
trebor127
Member
thanks for that CX
keith
keith
