- Joined
- Jun 29, 2015
- Messages
- 2
- Reaction score
- 5
Hey guys, I decided to share this little template with you all. I see a whole bunch for Glock, but none for M&Ps. This is kinda based on the Talon one, I guess. I didn't look at the Talon one before making one of my own but anyways, here it is. It's just for the side of the grip, I didn't tape the backstrap or the front finger area because curves are a pain in the ***.
So here it is, a template for you guys to use. Please use it as a general template and not 100% correct.
http://i.imgur.com/kKNQqFM.jpg?1
This is NOT full size and some modification to fit may be needed. You will have to print it out to standard US letter size (8.5x11 with no fit to paper) with a scale increase of 27-28%.
The bottom of the grip should be at 4.2cm if you printed it out correctly. If you print it out normally without resizing or whatever, the bottom would be at 3.3cm.
I hope you guys find this useful, and please reply with scale you think worked best for you guys. Help each other out. Thanks!
So here it is, a template for you guys to use. Please use it as a general template and not 100% correct.
http://i.imgur.com/kKNQqFM.jpg?1
This is NOT full size and some modification to fit may be needed. You will have to print it out to standard US letter size (8.5x11 with no fit to paper) with a scale increase of 27-28%.
The bottom of the grip should be at 4.2cm if you printed it out correctly. If you print it out normally without resizing or whatever, the bottom would be at 3.3cm.
I hope you guys find this useful, and please reply with scale you think worked best for you guys. Help each other out. Thanks!
