I have been Googling for days and have not found ANY source for an Extended Magazine Release for the SD9-VE.
Extended lots of other things? Yes.
The most useful one so far is the extended slide release latch.
What a difference a millimetre makes!
But I can't release the mag without moving my grip.
If you have a steady hand you can sand down the ridge by the magazine release or you can take out the mag release and build it up with some epoxy. At least you get the exended barrel free of charge in Canada.
If you have a steady hand you can sand down the ridge by the magazine release or you can take out the mag release and build it up with some epoxy. At least you get the exended barrel free of charge in Canada.
Great suggestion. Thanks.
Now, as to the matter of a "steady hand", that's debatable.
If it were me, I think I would remove the magazine release and wrap some 1/2 wide tape around the button part to create a form and fill with just a tiny amount of exopy/resin/etc. I would probably stipple it for some texture after it cured.
why mess up a perfectly good mag release button? put the epoxy on the end of your thumb, or get one of those red rubber thingies office girls used to collate and sort papers with...........just kidding.....I need some more coffee.,,on the other hand a nice stippled thumb tip might be purty...
Extended Magazine Release
Linear Mode
