sparkyvega
Member
I am considering installing a Tandemkross "Victory" trigger in my SW22 Victory. Not a kit, just the trigger. Has any one done thus, and if so, what were your impressions?
Tandemkross "Victory" trigger in SW22, your impression?
- Thread starter sparkyvega
- Start date
Register to hide this ad
I installed just the Tandemkross trigger in my Victory SW22, and it gave the perception of a lighter trigger pull, but actually the pull was much smoother, feels like a ball bearing just rolling off the sear. Also, as DBenn says, the flat trigger surface allows you to get a much better feel on how your finger is positioned on the trigger, and it gives better leverage which also makes the pull feel lighter. I think that it is the single best upgrade that you can do to a Victory pistol.
X ring hunter
Member
Works fine for me....
RGVshooter
Member
That itty bitty microscopic spring.....
Yes, this is correct. Even though I am totally happy with the results, getting the little trigger return spring and plunger in place was quite a challenge for me.
bbqncigars
Member
A slave pin really helped assembly for me.
misswired
Absent Comrade
As recalled; cock the hammer then install the plunger and spring.
The trigger is definitely an improvement.
The trigger is definitely an improvement.
Similar threads
