10-7 Center Pin

[45B10]

Bought a few of the 10-7's from J&G and have ran into my first hick-up of sorts. I ordered my barrels and all related parts from Numrich and apparently they were out of the elector rods so I had to reorder those. When they finally arrived it turns out I received the wrong center pins from Numrich, they're too short to reach the end of the ejector rod when depressed. Seems like a lot of places are out of the center pins and I'm honestly a little gun-shy to just order center pins not knowing which ones I have now and which ones I specifically need. Any help would be appreciated greatly.

 

[armorer951]

We'll need to know the barrel length you decided on in order to be of any help.

 

[45B10]

We'll need to know the barrel length you decided on in order to be of any help.

4in pencil barrel

 

[armorer951]

The correct factory number is 07472. I looked the usual places with zero results.

Perhaps you could call S&W Factory Service to see if they have them in stock. 1-800-331-0852

 

[Hondo44]

You can order a ctr pin for the N frame 4" barrel or longer and shorten it on both ends to work in your K frames. But you'll need a correct pin of the same vintage as your gun to observe so you know how much to shorten on either end for it's integral collar to be in the proper position. Or the dimensions of the K ctr pin from someone.

 

[RGNewell]

I have several new center pins. If you have the length I will check.
Bobby

 

[45B10]

I have several new center pins. If you have the length I will check.
Bobby

Sent you a PM...Chris