360 M&P Sight Change ?'s

[ajzent]

Don't know if I posted anything here about this but you're the experts - my used-in-box unfired 360's front sight (trijicon) didn't hardly glow - I mean at all! Even in the darkest of dark "faint" is generous - so - they sent me a new one wa-lah brightness- and I'd put it in but want a back-up roll pin so what size is it? I emailed them - no answer - this will determine punch and drill size as well. On the Brownell's exploded view of a j-frame it's #20 but that's not listed as a part that I can find - any help would be greatly greatly appreciated

 

[ajzent]

Don't know if I posted anything here about this but you're the experts - my used-in-box unfired 360's front sight (trijicon) didn't hardly glow - I mean at all! Even in the darkest of dark "faint" is generous - so - they sent me a new one wa-lah brightness- and I'd put it in but want a back-up roll pin so what size is it? I emailed them - no answer - this will determine punch and drill size as well. On the Brownell's exploded view of a j-frame it's #20 but that's not listed as a part that I can find - any help would be greatly greatly appreciated

 

[robotoid]

You need #54 and #55 wire gauge drill bits, probably about $1 each at hardware store. Roll pins available from S&W for about .50 cents each. Order a few, I always manage to bugger them up going in or out. A cup tip punch is the preferred pin removal tool, but I have used a flattened wire gauge nail too.

 

[ajzent]

I wasn't clear enuf- Smith backordered the pins - my question is - What size is the pin? What size pins do I need to order from Brownell?