.38 Safety Hammerless pin sizes

[9245]

Does anyone know the pin sizes on the .38 Safety Hammerless 3rd model?

I see pin punches at Brownells but they are very expensive so I would rather not have to buy the whole set if I can avoid it and just get the punches that I need instead.

I have also found some generic cupped punches in a 4 piece set in 1/16”, 5/64”, 3/32”, and 1/8” for less than the cost of one of the Brownells punches, will those work? I also found a tapered nail setter in 1/32” is that worth getting too?

 

[9245]

Anyone? I kind of need to order these soon, parts are already on the way and I can’t detail strip without punches.

 

[9245]

Update, that cheap punch set was absolute worthless garbage, all the punches were the exact same size, maybe 1/4” and they just had different size holes drilled in the front, useless. I have no idea what those could have possibly been for but they were completely misrepresented.

 

[9245]

Deleted. Wrong thread.