nitewatchman
Member
Apologies for posting in the S&W Forum but desperate times - desperate measures, etc.
I am looking for a TM or Colfax 80% Jig or at least the side plates for the jig so that I can mount a lower receiver in my Tormach CNC machine without damaging the lower or it's finish.
These make excellent machining and engraving fixtures to hold the receivers. I want to engrave the sides of the receiver and this makes a very good place to start. The suppliers are out of stock until at least December.
There has to be one stuck back in a corner somewhere.
nitewatchman
I am looking for a TM or Colfax 80% Jig or at least the side plates for the jig so that I can mount a lower receiver in my Tormach CNC machine without damaging the lower or it's finish.
These make excellent machining and engraving fixtures to hold the receivers. I want to engrave the sides of the receiver and this makes a very good place to start. The suppliers are out of stock until at least December.
There has to be one stuck back in a corner somewhere.
nitewatchman
