Bianchi CD series break-front cross-draw holsters have closed bottoms. I titled this query with CD-129 because it may meet my need. I have a revolver whose barrel is about .500-inch too long to fit my CD-129 - that is, it fits but is clearly not fully secured vertically within holster. Although the CD-130 meets my need, I cannot find the scarce CD-130 in an ultra-scarce left-handed version.
I can take my closed bottom holster to a saddle maker to have the closed bottom opened. As far as I can determine, opening the bottom will not harm the holster's spring action so long as flat spring set is stitched "closed" at each tip. Soaking the bottom inch of the holster in warm water, then thrusting the revolver into its correct position should have small amount of barrel peaking beneath the open bottom. I can then reseal the leather. Since bottom is open, most of that .500 inch of barrel should be cover by released "bottom" leather? This procedure is worth trying if the CD-129's flat spring set remains secure in its OEM position.
What do you think?
I can take my closed bottom holster to a saddle maker to have the closed bottom opened. As far as I can determine, opening the bottom will not harm the holster's spring action so long as flat spring set is stitched "closed" at each tip. Soaking the bottom inch of the holster in warm water, then thrusting the revolver into its correct position should have small amount of barrel peaking beneath the open bottom. I can then reseal the leather. Since bottom is open, most of that .500 inch of barrel should be cover by released "bottom" leather? This procedure is worth trying if the CD-129's flat spring set remains secure in its OEM position.
What do you think?