ATFE Form 1 & SBR Question

[agentofwrath]

I have a M&P 15-22 that I would like to have the barrel cut down to 10.5" and threaded. I know this involves a Form 1. What is a reasonable price once could expect to pay to cut, thread and crown the barrel on my 15-22. I have a trust in place that I used to get my YHM Mite, might I be able to use the trust again for the SBR? Finally do you have to engrave the barrel or somewhere else on the weapon? Thanks!

 

[BELT_FED]

first off cost should be no more than $50 plus shipping

second, the receiver is the sbr and that will need the engraving

and yes you can use your trust and it should make your paperwork alittle quicker... maybe... depending on the mood of the person that opens your envolope

 

[agentofwrath]

Thanks, where do you engrave on a plastic 15-22 lower? At what point must it be engraved?

 

[BELT_FED]

anywhere on the lower most do it on the sid of the mag well..

my local jeweler did mine and it was around 10 bucks