ronnie gore
Member
DELETE PLEASE
Last edited:
DELETE
- Thread starter ronnie gore
- Start date
Nice Job - looks great!
Duke426
Member
Very nice. I think stocks always look better with a set of medalions. You did a great job on those!
MAG-NUM
Member
Very nice job adding the logos. But I have to ask where you found the ..what is it...13/32" forstner drill bit to drill the holes. I was going to do the same thing but couldn't locate the correct size and type of bit. Thanks, Bob
OP
ronnie gore
Member
emblems
i used a 3/8 inch spade bit, tight but you tap them in place with a plastic mallet after putting in a small amout of j-b weld. since the ahrends grips have no washer it is necessary to drill a small hole all the way through to be able to tap them out from the back untill you drill a little at the time to get them to fit flush. it took 30 minutes.
practice on a piece of scrap wood first.
i used a 3/8 inch spade bit, tight but you tap them in place with a plastic mallet after putting in a small amout of j-b weld. since the ahrends grips have no washer it is necessary to drill a small hole all the way through to be able to tap them out from the back untill you drill a little at the time to get them to fit flush. it took 30 minutes.
practice on a piece of scrap wood first.
Last edited:
Similar threads
