Deltapoint mounting pattern

[teletech]

After having the sight work loose on it's adapter plate, I decided it's high time to mill the slide. Sure, I can measure the bolt/pin pattern, but that will take some time. I was hoping someone would have the dimensions or a link?
I did try a few searches and came up with many footprints, just not the one for the Leopold DP. :-(

 

[FAS1]

This might help.

Footprints/Mounting Standards on Red Dot Sights - Optics info

 

[teletech]

This might help.

Footprints/Mounting Standards on Red Dot Sights - Optics info

Seems like my sight is one of the very few they DON'T cover, apart to say it's less common. :-(
Well, I was going to have to make locating pins anyway and once those were made it didn't take that long to set gauge blocks between them.
Looks like the pin-pattern is 32MMx17MM and the pins are .160" in dia (I assume 4mm is the idea), the screws are 4mm, 14mm apart and appear to be 1" from the front for whatever reason.

 

[Imissedagain]

If you are talking about the Leupold Delta Point Pro, I believe it uses the Shield Standard pattern.

Shield standard Footprint - Optics-Trade

 

[teletech]

If you are talking about the Leupold Delta Point Pro, I believe it uses the Shield Standard pattern.

Shield standard Footprint - Optics-Trade

Ah, I'd missed them being the same, thanks for that.
I guess the DP and DPP are the same footprint, but not knowing that I had to assume they might not be. These numbers agree with mine apart from a .008" difference in overall length between the pins. I'm not sure who was right, but it could be we are down in manufacturing tolerances there since I cut mine to my numbers and it's a firm hand press-fit. This is nice since one of the things I don't like is having to zero the sight after changing batteries. I'm confident I'm not going to see more than 1" at 50 yards based on this fit and hopefully less than that.

 

[H Richard]

If I remember correctly the Delta Point uses the same pattern as the Burris FastFire.