Does the 6904 or 6906 grips coould fit a first generation 469?

[camachado]

Hi folks, I just boght a SW 469 (First Generation) with slightly damaged grips. Due to the age of the gun it is very hard to find replacement grips. However, I found tons of grips and accesories for the 6904, 6906 and 6946.

Do you think that 6904, 6906 or 6946 would fit on my 469?

Wich accesories of other SW guns can fit on my 469?

Thank you very much!

 

[ColbyBruce]

No, they will not interchange as the #469 uses seperate panels that are secured by the backstrap and the later models use a one piece design.

I don't know about factory stocks, but I do know where a brand new pair of Uncle Mikes stocks are for a #469/669 if you need them.

 

[Grog]

Get the UMs if you can, I put a set on a friend's 459 and they felt TONS better than the packys that were on there.

 

[camachado]

Thank you for the answers.

Where can I find the grips you are talking about Mister ColbyBruce?

Thank you again for the help!

 

[586L-Frame]

+1 on Uncle Mike's 469/669 rubber grip panels for a 469.
I have them on my two S&W 469's.
586L-Frame

DLC's S&W 469's with Uncle Mike's Rubber Grips.

 

[586L-Frame]

Get the UMs if you can, I put a set on a friend's 459 and they felt TONS better than the packys that were on there.

Special note.
459 grips will not fit on a S&W 469.
586L-Frame

 

[ColbyBruce]

I sent you a P.M. with the info. If they have a problem shipping out of the country, holler back at me and I will do it myself. I work for the USPS.

 

[Grog]

Special note.
459 grips will not fit on a S&W 469.

Uh......yeah.....I'm aware. I figured anyone reading this forum would figure out I was talking about the style of grips (UMs) and NOT the actual size