FSB taper pins

Joined
Dec 14, 2013
Messages
100
Reaction score
14
Location
charleston sc
Im thinking about retiring my Samson Evolution rail in favor of an M Lok handguard system. I installed the Samson myself after cutting my factory fsb down into just a low profile gas block. The Samson Evo uses a bushing around the factory barrel nut so I was able to install the handguard without removing the fsb from the barrel. All of the M lok handguards Ive been looming at use their own proprietary barrel nut. My question is, can I use the same taper pins as long I put my same cut fsb back on?
 
Register to hide this ad
Short answer... yes.

Removing them and reinstalling them shouldn't be an issue other than they may be pretty tight coming out. Just make sure to drive them out in the right direction. Whack on the small side of the pin during removal, not the large.
 

Latest posts

Back
Top