In chamber laser boresighter

[Crossbow]

Anyone use a laser boresighter that goes in the chamber to sight your scope in? Any issues with the bolt?

 

[sgtsandman]

Are you having an issue? I noticed on my 5.56 rifles that they do not like the A-Zoom snap caps but will extract and ejecting but will run regular rounds and made dummy rounds just fine. It appears the rim on the A-Zoom is a bit thin and thus the problem.

 

[Crossbow]

I haven't tried one yet, was thinking of ordering one.

 

[sgtsandman]

Ah! I do it the old way. Zero at 25 yards to get on paper and "walk" the rifle back to where I want to zero the rifle at or use an old style BSA grid bore sighter if the scope mount is low enough to use it.

 

[Zelicur]

I got one from Amazon for around $11. Works great and extracts.

 

[kosinar]

I just bought LaserLyte Boresighter for my M&P 10. I had a hard time to decide what to buy but it worked out great. It is skinny enough to fit inside flash suppressor. It has red laser that does not reach too far but it is fine to about 40 yards. I always just zeroed my scopes through the bore but this is much easier and faster.

 

[NJM15]

Laserlyte , works good

I just bought LaserLyte Boresighter for my M&P 10. I had a hard time to decide what to buy but it worked out great. It is skinny enough to fit inside flash suppressor. It has red laser that does not reach too far but it is fine to about 40 yards. I always just zeroed my scopes through the bore but this is much easier and faster.

Used it on several firearms lastly on my M&P 10 with a red dot x2 had both dots lined up and went to the range, and was hitting about 2" left . that's close enough saved some ammo and paper too