Wyatt Burp
Member
I've been making dog collars occasionally and just finished this one for my grandson. His dog was 7th in the litter, hence his name. The hollowpoints are 9MM in powder and primerless .380 brass. The rimless cartridges are staked through the back of the collar under the lining with cut down superglued finishing nails going into the bullets so they'll never fall out. Depending on your dog's size (the bigger the better), I can make one for you, too. $75 shipped to lower 48 states. It can't be too little of a dog, though. This is about the minimum being a dog with 14" neck and 1 1/4" wide collar. I've made a bunch like the one on the bottom and think the two-tone dyed with bullet loops would look a lot better than this black one.
Here's one I made for my grand daughter's dog.



Here's one I made for my grand daughter's dog.

Last edited: