Lee Factory resizer/crimp die

[epj]

I think of the FCD as an insurance policy. Most cases would work just fine as is, but there are a few that might not. I'm in favor of crimping as a separate step, since I usually load cast bullets. If you load on a progressive, there is no more work involved in using it. If you load on a single stage or turret, then you need to decide if you really need it.

 

[jrplourde]

Lfcd

If you are loading over sized cast bullets cus your bore or chamber throats require it, the the LFCD will resize the bullet as well. Not a good thing.

Bob

 

[Ranger325]

This may be a dumb question, but here goes.
I'm setting up a newly acquired RCBS progressive press for .38 - do I use the factory crimp die for flush seated
wadcutters for my M52-2?
Thanks,

Regards,