Loading 9mm Shield

[Tprobe]

Was going to buy this but noticed this at the bottom of the page

* The UpLULA™ does NOT load the following:

S&W 7rd 9mm SS (Beak too wide, does not enter between lips).

Anyone know if this is this referring to the shield mags?

 

[mistahd]

Was going to buy this but noticed this at the bottom of the page

* The UpLULA™ does NOT load the following:

S&W 7rd 9mm SS (Beak too wide, does not enter between lips).

Anyone know if this is this referring to the shield mags?

It works on my Shield 40 mags.

 

[ndpuckhead]

Was going to buy this but noticed this at the bottom of the page

* The UpLULA™ does NOT load the following:

S&W 7rd 9mm SS (Beak too wide, does not enter between lips).

Anyone know if this is this referring to the shield mags?

Works great on my 9mm Shield as well.

 

[Don 73]

My 9c does the exact same thing from loading the last round in the mag to hard loading of a full mag with a closed slide. I just use a little extra when I shove then into place.

 

[hpfenning]

Was going to buy this but noticed this at the bottom of the page

* The UpLULA™ does NOT load the following:

S&W 7rd 9mm SS (Beak too wide, does not enter between lips).

Anyone know if this is this referring to the shield mags?

I haven't had any problems loading my 9mm Shield mags.

 

[gfy1960]

All together now. UPLULA!

 

[Stimpy]

The Uplula that I have for my M&P 9mm FDE works just fine loading my Shied, both 9mm and 40. Not as smooth and fast as the FS, but works just fine.

 

[cjf77]

It loads Shield mags with no problem.
I do not like the mags. I cut 2 links of spring folds off my mag springs and they were still to stiff to load. Uplula works but is a lot slower than using your thumb. A lot slower. S&W needs to correct this.

 

[Tprobe]

Thanks all for the info!