Looking for correct optic

[LayDShtr]

Got the C&H plate installed. Fits ok, just a slight rise in the front of the plate when the screws are tightened, and no, I am not over tightening. So the result is the plate does not sit completely flush with the slide cut out. I can live with it. It’s subtle.
Pics to finish out this post.
Last pic is to show how it fits in my Kenai chest holster. Fits and draws very well!
Now if I can just find some dang Buffalo Bore 200 or 220 gr 10mm hardcast up here in Alaska. Or some Grizzly 10mm. Supply issues apparently.

 

[reloaderguy]

Anyone know if this optic can be used on the M&P 2.0 45 ACP?

 

[Beju]

Anyone know if this optic can be used on the M&P 2.0 45 ACP?

If you have a factory optics ready model (only current optics ready 45 is the threaded barrel model, SKU: 13586), it should work exactly the same as on the 10mm.

Otherwise, you can get your slide milled.

 

[reloaderguy]

If you have a factory optics ready model (only current optics ready 45 is the threaded barrel model, SKU: 13586), it should work exactly the same as on the 10mm.

Otherwise, you can get your slide milled.

Yes that's the current model and configuration I have. Thanks.

 

[Beju]

You're welcome. FWIW, C&H Precision has become known for spotty QC in the past few years. My 2 older C&H plates (RMR pattern for M&P 2.0, and one for CZ P-10) fit very well, but my newest plate to mount a Holosun 509 ACSS on an M&P 2.0 is kind of sloppy. I half expect it to come back at my face one day at the range.

Other plate options that have been getting pretty good reviews lately are Calculated Kinetics and Athena Precision.