M&P 9FS trigger reset

[HoseMonkey]

After spending allot of time reading I haven't found any definite answers. I have a M&P 9 FS I put a Apex DCAEK in it with the polymer trigger. I am happy with the pre travel reduction, trigger reset travel and the trigger pull. However I am not happy with the trigger reset. It's non-existent, you can barely feel it or hear. Un like the reset on my Shield with the same kit. On my Shield it's definite. I had to replace the Sear Housing Block because the Sear spring in the kit is 1/8 and my original Sear Housing block had a 1/16 spring. Also Since I have replaced the Sear Housing Block should I also replace the Locking Block to keep wear even. Any feed back is appreciated.
Does any one have any suggestion for me. I have emailed Apex twice with no reply Thank you for your help. Be Safe!

 

[DMSC]

The DCAEK doesn't do anything to increase audible/felt reset.

You have two choices...install the APEX RAM or install the latest slide stop lever assembly.

I'll recommend the later for two reasons:

1) It increases the audible/felt reset.

2) It is reinforced in the area where some old style slide stops have failed.

You can replace the locking block if it shows a lot of wear but you don't need to do so otherwise.

 

[HoseMonkey]

S&W FS 9 Trigger reset

Thank you for responding to my thread. It's been driving me crazy. S&W said they didn't want to look at it because of the trigger kit being installed and Apex never replied to my email inquiries. I'll order what I need tomorrow. I'll let you know how things turn out.
Thanks again.
Be Safe