M&P45 Trigger job help

[MADman23]

Hi I own a fs M&P45 ambi thumb safety, no mag release safety. Id like to get rid of some of the take up AKA pre-travel, reduce reset and over travel, slightly lower my poundage on the trigger pull. While maintaining stock thumb and trigger safeties, and keeping the same springs. My gun works great around 7200 rounds through it, would just like a better trigger especially with it being my EDC. I've been looking at accurate iron, Burwell gunsmithing, if you would recommend one or a suggestion of your own it would be appreciated. Thanks guys. Hey and protect our rights join the NRA! Happy holidays [email protected]

 

[magnum12pm]

Hi I own a fs M&P45 ambi thumb safety, no mag release safety. Id like to get rid of some of the take up AKA pre-travel, reduce reset and over travel, slightly lower my poundage on the trigger pull. While maintaining stock thumb and trigger safeties, and keeping the same springs. My gun works great around 7200 rounds through it, would just like a better trigger especially with it being my EDC. I've been looking at accurate iron, Burwell gunsmithing, if you would recommend one or a suggestion of your own it would be appreciated. Thanks guys. Hey and protect our rights join the NRA! Happy holidays

You might want to go to the Burwell website and take a look at their DIY article. Its fairly easy to reduce trigger pull and reset on the MP.

 

[MsDarla]

http://www.burwellgunsmithing.com/misc/M&Ptriggerjob.pdf

 

[alphabrace]

Rookie gunsmith in training or to cheap to pay someone

I just might try to do this trigger work on my 9mm M&P. Question is if I screw up any of the parts can I buy them from S&W or someone?

 

[MADman23]

Any other suggested smiths other than burwell or accurrate iron.

 

[robmcd]

David Bowie of Bowie Tactical Concepts also does a great job on M&P's. http://www.bowietacticalconcepts.com

I've had 2 done by Dan Burwell - great work.