ks farmer
Member
Someone ground part of the hammer spur off my.32 who would have such a part?
Model 31 hammer
- Thread starter ks farmer
- Start date
Register to hide this ad
- Joined
- Jun 28, 2007
- Messages
- 27,669
- Reaction score
- 21,355
It is a standard J frame hammer, as would fit a model 36 J frame .38. Numrich or other parts suppliers should have one but it may not drop in without minor fitting.
It depends on the vintage of your .32. We'll need a serial 3 or partial #.
the two main issues are:
1. pre or post war gun to match the hammer safety block? and
2. in post war models, leaf or coil mainspring?
You have lot's of potential hammers that interchange with yours:
I and J frame .32s, 38 S&Ws and .38 S&W Special
Numeric is the easiest way to get one if they have it, once we know which vintage you need.
the two main issues are:
1. pre or post war gun to match the hammer safety block? and
2. in post war models, leaf or coil mainspring?
You have lot's of potential hammers that interchange with yours:
I and J frame .32s, 38 S&Ws and .38 S&W Special
Numeric is the easiest way to get one if they have it, once we know which vintage you need.
Last edited:
In that case, any post model 1960 j frame hammer, any caliber (except rim fire of course) up to the mid 1980's MIM HAMMERS with frame mounted firing pins, will work.
Last edited:
- Joined
- Jun 28, 2007
- Messages
- 27,669
- Reaction score
- 21,355
Green Frog
Member
Vendors on Gun Broker frequently list "Parts Kits" derived from the salvage of parts from guns to be destroyed. Often the whole kit sells for about what it would cost to get one or two parts from Numrich, etc.
Froggie
Froggie
george_lehr
Member
Years ago, I bought two J frame hammers on Gunbroker. They had lots of parts. I recall selecting one and then continuing to look and found one with nicer case hardening.
George
George
