Model 52 extractor

[bondsg]

I have two model 52's and I have broken the extractor on one. I can find no replacement extractors. Any help?

 

[jrm53]

If you have the pieces of the extractor any decent machinst could mill one out of flat ground and quench it after it fits and functions as long as you have a good pattern to measure I think it could be done. Jeff

 

[bondsg]

Good idea, Thanks, I'll try that if I can't find one

 

[tommix]

Model 52-2 extractor

Call "Guns and Gun Parts" , in West Springfield, Mass. and talk to Michael. I bought 2 new extractors from him 1 month ago. Phone number is 413-732-9938. I was referred to him by someone on this forum, cost was $30.00 plus $5.00 postage each. Good luck...

Bill

 

[jbrown13]

If the one that is broken is a pre-dash model, you can buy an extractor at the link below on page 6. This extractor will not fit a 52-2 and I'm not sure if it will fit a 52-1.

Numrich Gun Parts Corp. - The World's Largest Supplier of Firearms Parts and Accessories

 

[civil1977]

The 52 and 52-1 use the older style long extractor. The 52-2 uses the shorter design.

 

[bondsg]

52

Thanks for all the info!