Model 58

Hoptoad

Member
Joined
Apr 30, 2013
Messages
115
Reaction score
28
Location
West Virginia
I finally had time to get to the range with my 58 today. I bought it from a member here and have been rained out or scheduled out since it arrived. It's a very clean shooter grade gun. Moderate blue wear, mostly at the muzzle. It has been well cared for. It has Jordan Trooper grips and someone did a very professional installation of an orange insert in the front sight. It's a late '64 gun.

The first six rounds were 215 gr LSWC target loads. Windage and elevation were dead on at 15 yards with a 6:00 hold. Dead on at 25 with a center hold with the same 1" orange dot. With stout Underwood 210 gr loads the POI was nominally higher. It was easy to shoot with both loads and very accurate. I'm pleased and impressed.

My 6" Blackhawk 41 hammered my knuckle with the trigger guard with the heavy loads to the point that I started to flinch. And I'm pretty flinch proof. The Blackhawk may go down the road. My newly acquired 57 (1968) is getting a new orange insert so I wasn't able to take it along. I expect it too will be an excellent shooter.

Dave
 
Last edited:
Register to hide this ad
Anybody else remember that old saw from the 1960s that the Model 58 was less strong than the Model 57? George Nonte put the lie to that in '73. I also recall that the 210 gr factory LSWC 'service load' was very soft and smoky when fired, giving off an odor of burning wax. Don't think that load is produced anymore. Yeah, I know, gotta handload.
 
kaaskop49 - do you recall the velocity of the old LSWC loads? Mine are running about 900. The Underwood hunting loads are booking 1300-1350.

Yes, it was a fine day. I also took along my 38 Supers and my CZ 82. Range conditions were excellent so it all made for a pretty sweet outing.
 
The 210 lead "Police Load" was doing 950+- from a 4" barrel. I have a few rounds left and plan to do a chrono and water penetration test soon.

Bob[/QUOTE

Good morning Bob! I'll be interested in the results. What velocity will be a reasonable limit to avoid leading?
 
With modern hard cast bullets you will get little to no leading at any velocity you can get from a 4" barrel. The problem with the original Remington and Winchester bullets was that they were soft swaged lead and had no gas check like the .44 Magnum rounds did.

Bob
 
Aloha,

With hard cast 210 grain lead bullets, my loads were chrono'd at an honest

900 fps over 7 grs of Herco.

I used that in IPSC and also for bowling pins.

Works well in bth 57 and 58.
 
Back
Top