New to me Md 459; mag issues

[cporfe]

I recently picked up this Md 459 off GB and took it to the range yesterday. The gun ran well. The original mag ran flawlessly. I have 3 like new MecGar 17 round mags I used on a RSR Md 6590 I sold, stupid I know. One stainless steel mag fit and fired okay, but I had to pull the mag out as it didn't drop free. The other two MecGars are blued and they would act like they were locked in place but were probably friction fitting. After chambering the first round, the trigger wouldn't work. I had to lock back the slide and pry the mags out by pushing in from the slide opening and pulling on the bottom. A major disappointment.

And ideas?

I just get some replacement wood grips from Thailand. Required a little fitting. They are a lot thicker than the original plastic ones so I don't know if I'll like shooting with them.

Thanks
Chris

 

[Tntcwg3]

The wood grips really give the 459/559 pistols a classy look!

 

[stansdds]

Wonder if the trigger's draw bar has been pushed into the magazine well a little? Maybe a raised edge or bur on the draw bar intruding into the magazine well?

 

[Sevens]

Totally agree.

Step one is to yank those foreign stocks and install the original plastic grips and try these magazines again and see if they work.