Newly acquired Model 10 & 67 and question

[winmagbar]

Hello,


I recently acquired an almost mint condition Model 10-5 made in 1968. After researching I shipped the Model 10 to Nelson Ford for an action job and thought I was happy.


I then saw a Model 67 on gunbroker that had already had an action job by Nelson. Hmmmmm, bought it too. Both pics are attached. Now for my question, I spent the better part of last night looking for a Brushed Tyler T Adaptor for the model 67. I am going to post in classifieds but if anyone has one they could part with, please PM or email me. Lots of good information here, I imagine I will be spending quite a bit of time on the forums.


Thanks
Robert

 

[bananaman]

I have both guns myself, except my 10-5 is a 2" from 1974. Everyone is different, but I use Target stocks on most of my revolvers. Magnas, and grip adapters just don't work for me. Just an idea. Bob

 

[Ivan the Butcher]

Two summers ago I picked up a 6" 10-5 in like new condition. With may standard 38 special ammo 158gr @ 850fps my first 50 rounds were a 1" ragged hole at 15 yards That gun from the factory had the best action job, better than my brother's late 60's Python!

Ivan

 

[Moo Moo]

Nice purchase.

Coincidentally, I bought a similar model 10-5 and a 67 (albeit a Dash 1) at the same time about three years ago. I went to see one of my dealers in Sydney, looking for a Colt Cobra. Came home with these two instead.

 

[winmagbar]

Yours look like they are in excellent condition!

Robert

 

[jimmyj]

I prefer "BK" grip adapters over "Tyler"