PC 327 2"

[cce1302]

I have the 2" PC 327 and am not happy with it right now, but I hope to be once I get it back from SAW. The cylinder seems to be contacting the lower part of the frame right next to (crap I can't remember the terminology) the piece that keeps the cylinder from turning. The finish is coming off the frame right there and the cylinder is showing wear right near the back end. This is after <200 rds of .357 magnum factory ammo [Hornady, UMC, and some other stuff, 125-158 gr). I'm sending it out tomorrow. Hope to have it back soon. I asked someone who would know, and he said it sounds like the crane may be slightly bent/out of wack. It's pretty disappointing, but I expect S&W to make it good. I will certainly post the outcome.
Not really asking anything with this post; just sort of talking, hopefully to guys that understand.

 

[cce1302]

I have the 2" PC 327 and am not happy with it right now, but I hope to be once I get it back from SAW. The cylinder seems to be contacting the lower part of the frame right next to (crap I can't remember the terminology) the piece that keeps the cylinder from turning. The finish is coming off the frame right there and the cylinder is showing wear right near the back end. This is after <200 rds of .357 magnum factory ammo [Hornady, UMC, and some other stuff, 125-158 gr). I'm sending it out tomorrow. Hope to have it back soon. I asked someone who would know, and he said it sounds like the crane may be slightly bent/out of wack. It's pretty disappointing, but I expect S&W to make it good. I will certainly post the outcome.
Not really asking anything with this post; just sort of talking, hopefully to guys that understand.