S&W Model 60 Pro What do you think?

[Chopaka]

These are some pics of a brand new unfired,other than by S&W,Model 60 Pro.This revolver was a replacement for an S&W airweight with a cracked frame.When I received this brand new revolver two weeks ago it had a canted barrel,so I sent it back to S&W for repair,they fixed this problem.It was returned today with the canted barrel fixed,Thank's.However upon closer inspection there are a couple more issues that I did not notice before I returned it the first time.Three of the rear sight screws are boogered up.The rear sight channel is not finished the same on both sides,the left side fits the sight perfect while the right side has gaps and uneven metal.The frame on the right side above the cylinder has had a lot of metal removed compared to the left side of the frame,which looks as it should.It would seem that this is not the place to be removing metal.I will contact S&W Monday,I am sure they will make it right.

 

[Ashlander]

I looked at the photos before reading your text and couldn't see anything wrong except the boogered screw, but then after reading the text I went back and looked again -- I think I see what you're talking about with the lack of symmetry. I'm not sure all of what it takes to refit a crushed canted barrel, but I wonder if the process required a little "cleaning-up" of the frame afterward and goodbye a little metal?