S&W Model 637 QC lacking...
- Thread starter JSandi
- Start date
Register to hide this ad
1991a1colt
Member
Wow, that's very messed up.
Sent from my rotory phone using Tapatalk 2
Sent from my rotory phone using Tapatalk 2
Yeah, I wonder what S&W would do to make it right, and how long that would take.
I'm not sure what's off. Is the barrel not clocked properly, are the chamfers on the sides of the top strap cut unevenly or is the sight groove off center? You photo appears to be looking straight down and the left side chamfer looks much deeper than the right.
Does it shoot to point of aim?
Does it shoot to point of aim?
Its the trench along the top is way off... its too far to the right side of the gun, not even down the center.
Sight alignment is nearly impossible as the front blade is almost half way out of the rear notch (way to the left) to achieve hits.
Last edited:
Contact S&W and they'll make it right. Here's a link to get a prepaid shipping label: Warranty Repair Shipping Form - Smith & Wesson
1991a1colt
Member
Yeah but i guess Smith and Wesson sigma manufacturing went out the window... Wow
Sent from my Nexus 7 using Tapatalk 2
Sent from my Nexus 7 using Tapatalk 2
daven59
Member
Just about every time I shoot something new I'm 2 inches to the left of X so with that one I wouldn't have to make a sight correction LOL!
Just checked my 438 and I think my eyes were playing tricks on me and thought it was off very slightly to the right but its okay and any way it shoots very accurate from 5 to 15 ft as its intended use.
Just checked my 438 and I think my eyes were playing tricks on me and thought it was off very slightly to the right but its okay and any way it shoots very accurate from 5 to 15 ft as its intended use.
Last edited:
