Upper Rec fixture?

[wpriest]

Any recomendations for a fixuture to hold my M&P 10 upper. I just ordered a Troy quad rail (mrf-308) so I know I have more to do than just remove the round handguards.

I have blocks for my AR-15 but they are a bit undersized for the M&P 10

Thanks
Bill

 

[cb4017]

I used the receiver blocks from Armalite. They're made to work with 5.56 and 7.62 flat-top uppers.

 

[jbowpsp]

I got the ones off of ebay for $20 shipped. They are an unbelievable deal, and work for AR15 and AR10 uppers. The cool thing was the block for the lower side of the upper has two cutouts made so it can fit either size upper, but the smaller cutout fit over the pin-base just fine on our rifle. If I had AR15 blocks and they fit the bottom I would just use them and not buy another set. The top (rail side) is the same size regardless so you are paying to use only 1/2 of the set essentially if you buy a new one.